Skip to content

KAZOO Support Channels

This documentation is curated by 2600Hz as part of the KAZOO open source project. Join our community forums here for peer support. Only features in the docs.2600hz.com/supported space are included as part of our 2600Hz Support Services plan.

Zoiper

Manually configure Zoiper softphone#

Where to get info#

Values for filling in the zoiper fields are found in Kazoo's UI's device details. Kazoo's UI is called Monster, for future reference. You probably created a Softphone type device so the settings should be on the basic tab. Most other types you will find them in the Advanced, SIP tab.

Configuring Zoiper#

  1. On zoiper, click Settings, Preferences.
  2. On the left, near the bottom, click Create account
  3. Select SIP, click Next.
  4. NOTE: To paste in the zoiper field you have to right click the field and select Paste.
  5. for user@host copy the username@realm as found in field's matching username and realm in Monster UI.
  6. for password, copy the password from the password field in Monster UI.
  7. Click Next.
  8. Give it a short meaningfull name like "Jay office".
  9. Check Skip auto-detection.
  10. Click Next then Close.

On the General tab#

  1. Domain should be already set to the devices realm.
  2. Username should already be set to match what is in Monster.
  3. Password should also already be set to what you copied from Monster.
  4. "Use outbound proxy": check
  5. Outbound proxy: one of the following depending on which is closest to you. You may want to check ping times. us-west.p.zswitch.net us-central.p.zswitch.net us-east.p.zswitch.net

Account's Extra tab#

  1. Register on startup: Check
  2. Voicemail extension: *98
  3. nothing else checked or filled in for this tab

Account's Advanced tab#

  1. registrations expiry: 600
  2. Keep alive timeout: custom: 15
  3. Dropdowns along right should see
  4. "Use DTMF RFC-2833"
  5. "Use UDP transport"
  6. "TLS with no SRTP"
  7. "Don't use STUN" <- VERY IMPORTANT
  8. "Use certificate as:" "Don't use"
  9. Use rport: Checked
  10. Use rport media" Checked
  11. NOTHING ELSE checked or filled out.

We do not use STUN, TURN or anything else like that. They just mess things up. Note that the Outbound proxy addresses have SRV records so in the case of a outage to the primary location, the phone will be able to make outbound calls normally and within 300 seconds re-register to get calls through the failover route. DO NOT decrease the registration's expiry below 600 seconds. With an expiry of 600 it will actually re-register every 300 seconds (5 min). Lower values put too much load on the servers.

Also refer to the SIP best practices and Troubleshooting guide https://community.2600hz.com/customer/portal/articles/2130224